To start with part 2 goes through an explanation of the breadboard, resistors and LED’s. We then are asked to go and collect the components we learned about as you can see below. A 1k ohm resistor, an LED and our power supply and breadboard. Continue reading “Part 2 – Introduction to using a breadboard”
Part 1 – Intro to Soldering and Building Power Supply
This is the first post for my Mt. Sac class Electronics 10 Mechatronics. In this lab we got to play a bit with some of the basics of electronics.
The lab is divided into two sections, learning how to solder (which I’ve done a lot of in the past, even though you can’t tell from the quality I exhibit below), and then applying that soldering technique to building the power supply I will use for the remainder of the class. |
Continue reading “Part 1 – Intro to Soldering and Building Power Supply”